No Gravatar

You know the guy at your flying field there always seems to have problems and luck is not in his dictionary. I AM THAT GUY, with no luck :)

But i have learned to live with it :)

On the positive update, i got the Frenzy airborne and yes it flies nicely, here you can see below i made a small takeoff in my garden just to check the engine. The video is to boring this is just a screenshot of the video

1airFrenzy90.jpg

That was a good start some days after i was heading to the flying field, well this day i would like to forget about this day, i flooded the engine resulting in the clutch coming loose, resulting in binding the clutch and no flight that day, as you can see from the pictures below, first day at the field bummer. But the Frenzy was easy to disassemble compared to the Freya.

IMG_1946.JPGIMG_1948.JPGIMG_1949.JPGIMG_1952.JPG

Some days after i headed to the field again, a very windy day but hay no problem it a helicopter right. You can’t setup a gyro in hard wind but i could still get it up in the air, and i did it went well, i did some engine tuning and some gyro tuning, had some small tail wag but with some adjustment i was gone. While i am on the subject gyro setup let me show you a good link this is a QA from Spartan, very good information http://www.spartan-rc.com/support.php

IMG_1997.JPG

But then the problem started, suddenly in a low upright flight the helicopter just started spinning very fast it is my luck that i am practicing piro maneuvers with the throttle hold i manage to land the helicopter without a scratch.

With some post flight inspection i discovered that the tail was stating to some off or the axis on the tail was. A lesson to all of you when you get a preassembled model check every screw on the model, i apparently missed two at the tail. As you can see from the pictures the two screws holding the tail axis was not placed correctly resulting in the tail sliding to one side and the helicopter doing aggressive piros.

IMG_2000.JPG

IMG_1990.JPGIMG_1993.JPGIMG_1999.JPGIMG_1998.JPG

Here you can follow the build process of the Frenzy 90 day by day, or night by night if you like:
Day 1
Day 2
Day 2½
Day 3
Day 4
Day 5